APPLICATION INSTRUCTIONS
BUFFER WATER TO PH RANGE OF 5.0 to 7.5
PEST-KOTE® may be diluted and applied with conventional application equipment including but not limited to compressed air sprayers, back pack sprayers and power sprayers.
1. Fill spray tank half full with water and begin agitation.
2. If foaming is expected, add silicone based antifoam to the tank.
3. If used as a tank mix, add pesticides and/or foliar nutrients as directed on their respective labels; maintain agitation.
4. Continue filling with water until the tank is ~90% full
5. Add the required amount of PEST-KOTE® and mix thoroughly. Add the remaining water to 100% full.
COMPRESSED AIR/HYDRAULIC SPRAYERS: For surface applications apply as a course, wet spray at the specified dilution rates listed below. For crack and crevice applications, place the tip of the applicator at or into the crack, crevice or void to be treated apply product at the rate of one second per foot. Apply in such a manner as to limit dripping and runoff on surfaces and plants.
HOSE END SPRAYERS: Dilute according to the specific directions for use. Shake sprayer to fully mix the product.SPECIMEN LABEL
Rev 02/07/2024
This specimen label is intended for use only as a guide in providing general information regarding the directions, warning and cautions associated with the use of this product. As with any pesticide, always follow the label instructions on the package before using.
LOW-VOLUME SPRAYERS (including but not limited to backpack sprayers, turbine sprayers, orchard sprayers, mist blowers): Dilute according to dilution table or specific directions for use. Direct the nozzle(s) into the plant canopy to get good penetration and coverage, maintain the appropriate distance from the plants to avoid blast damage. The operator should visualize that all the air within the canopy must be replaced by the air from the blower.
USED AS A TANK MIX: PEST-KOTE®is compatible with the most commonly used nutritionals, herbicides, fungicides, insecticides and plant growth regulators. PEST-KOTE®is a 96% organosilicone product. It is the pesticide user’s responsibility to ensure that all products are registered for the intended use. Read and follow the applicable restrictions and limitations and directions for use on all product labels involved in tank mixing.
Users must follow the most restrictive directions for use and precautionary statements of each product in the tank mixture. The user or application advisor must have experience with the combination or must have conducted a phytotoxicity trial.
