Lidoquest Copper EDTA 15% 55 pound bag
In hydroponics copper EDTA 15% improves the efficacy of Fe-chelates. Though the pH in the irrigation water is around pH 6, the pH in the fertilizer tank can be very low. LidoQuest copper EDTA 15% is stable from pH 1.5 - 10.
Never bring copper EDTA 15% in direct contact with concentrated acids.
Vegetable crops (tomato, cucumber etc.) do need 0.75 µmol Cu/l (0.048 ppm) continuously, flower crops 0.5 µmol Cu/l (0.032 ppm).
Foliar feeding provides a rapid response and is recommended when fast correction is necessary or soil application is expensive and impractical, or impossible, for example if the soil is extremely wet. Repeated applications might be necessary. For improving leaf coverage it is advisable to add a wetting agent, efficacy may be further increased by adding urea. Dissolve the product to a suitable concentration, and apply with spraying equipment. The pH of final concentration should be lower than 6.5, final EC lower than 1. Dose rates for a specific crop should be tested first on a small scale. When copper deficiency is severe, repeat the application after 3-4 weeks. Apply copper EDTA 15% in vegetative or growth stage of the crop. To reduce the risks of leaf scorching avoid application during hot, sunny days. Treatments in the early morning are preferred.
The product can be mixed with most other fertilizers and agrochemicals without inactivation, precipitation or scorching problems. With liquid fertilizers use the mixture without delay. Test mixed product first on a small scale.
Add the required amount of product to a half filled sprayer tank, then complete the filling process. Ensure that sprayer nozzles are adequate for 200-1000 liters water/ha. Use the higher volume under dry conditions, when treating larger crops and at dense foliage.
- Store in original container, keep tightly closed and store in cool dry place
- Store away from children, pets, livestock and foodstuff
- Wash hands after application and before meals
WARNING:Harmful if swallowed, Do not breathe dust, Avoid contact with skin. In case of contact with eyes, rinse immediately with plenty of water and seek medical advice No health hazards are involved in normal handling of copper EDTA 15% but it is advisable to follow the above precautions.
Table A: Application rates for greenhouse crops
||Cu defecient soil/compost
|For every watering
||3 week interval
||0.6 g/1000 liter
||0.2-0.4 g/1000 liter
||0.5 g/1000 liter
||0.2-0.3 g/1000 liter
|Potted flowers, pot plants
||0.2 g/1000 liter
Table B: Application rates for arable crops and open field horticultural crops
|Soil Application, arable crops
Apply pre-drilling or pre-planting to bare
soil in a convenient volume of water, cultivate after spraying
|Soil Application, horticultural crops
Apply though the watering system.
Use enough water to wet the top 10 cm of soil.
Use clean water immediatley afterwards to wash
the copper chelate from the foliage. Or use the last
5 minutes at the foliar application rate.
||Apply in a water volume that gives adequate coverage of the crop (200-1000L) Do not exceed a concentration of 0.1%
|1 kg/ha = 0.9 lbs/acre
||1 g/l = 0.13 oz/gallon
Copper EDTA 15% chelated fertilizer
||blue, blue-green powder
|Copper chelated: %
|Water insoluble: %
|pH value (1% solution)
This product was added to our catalog on Monday 18 August, 2014.